How to Mount a Sim Rig Cup Holder and Button Box Cleanly

Quick answer

Mount your cup holder and button box by first planning their positions on the rig, then securing each with the provided hardware, and finally routing cables neatly. Use a dedicated button box mount for adjustability and a simple profile-mounted cup holder for drinks. Always check that accessories don't interfere with your wheel or pedals.

Plan accessory positions before you tighten anything

Before installing any sim racing cockpit accessories, sit in your rig and identify where your hands naturally fall and where a drink won't obstruct your view or controls. The cup holder should be within easy reach but away from electronics and moving parts. For the button box, consider whether you want it angled toward you or flat; a mount with tilt and swivel gives you flexibility. Mark tentative spots with tape, then test reach and clearance before committing.

Install the cup holder on a stable profile

The Cup Holder from Advanced SimRacing mounts directly to your chassis profile using two M5 screws and T-nuts. Slide the T-nuts into the profile slot, position the holder, and tighten the screws firmly. Avoid mounting on a motion or haptic platform, as the manufacturer does not recommend it—vibration could spill your drink or loosen hardware. Check that the holder doesn't interfere with your legs or the wheel.

Mount the button box with adjustability in mind

Use a dedicated button box mount like the Button Box Mount, which features dual sliding universal mounting brackets and tilt/swivel adjustment. Attach the brackets to your button box, then secure the assembly to your rig's profile or wheel deck. Tighten gradually while checking that the box sits at a comfortable angle and doesn't obstruct your view. Make sure cables have enough slack to allow full movement.

Route and secure cables for a tidy rig

With accessories mounted, route cables along the rig's profiles using zip ties or cable clips. Keep cables away from moving parts like the wheelbase and pedals, and leave a service loop near the button box so you can remove it if needed. Label both ends of each cable to simplify troubleshooting. A clean cable setup reduces strain on connectors and makes future upgrades easier.

Step-by-step installation

1. Test-fit accessories: Hold the cup holder and button box in candidate positions while seated in your rig. Check reach, clearance, and sightlines. Mistake to avoid: mounting too close to the wheel or pedals.
2. Secure the cup holder: Slide T-nuts into the profile slot, position the holder, and tighten the M5 screws. Ensure it's level and stable. Checkpoint: the holder should not wobble or obstruct leg movement.
3. Attach and adjust the button box mount: Bolt the universal brackets to your button box, then mount to the rig. Adjust tilt and swivel before final tightening. Mistake to avoid: over-tightening before checking ergonomics.
4. Route cables neatly: Use zip ties or clips to secure cables along profiles, leaving slack for movement. Label cables for future reference. Checkpoint: no cables under tension or near moving parts.

Product facts

• Button Box Mount: Button Box Mount features dual sliding Universal Mounting Brackets and swivel/tilt adjustment. Lets you position your button box at the ideal angle and reach for your driving style.
• Cup Holder: Cup Holder mounts directly to Advanced SimRacing-brand chassis with two M5 screws and T-nuts; not recommended for motion or haptic platforms. Provides a secure drink spot on static rigs but may spill or loosen under vibration.